Tired of fabrications on products you never seem to have on hand?
Custom short run stamping (inexpensive tools) from a USA source: simple parts like brackets are often under a $1.00; usually under $2.00 with holes and embossments and bends- some parts we can do with house tooling and bespoke tooling starts at about $300 for the life of the parts with no customer upkeep or repair charges. We offer plain, plated, stainless and aluminum stamping.
This is not progressive tooling costing tens of thousands of dollars but a simple punch and die set that we keep in running condition.
If your parts look like these we may be a contract stamper you should consider us.
Recently (2013), we quoted 2,000 pcs 3/16ths thick and 2” x 3 9/16” flat plates zinc plated with holes for 85¢ each with $585 tooling fee a laser operator had quoted the same part and quantity for $1.55 each. On the first order there was a savings in spite of tooling costs.
Parts can be as thin as .010 or as thick as .375 mild steel; or .120 stainless steel
A sample run is recommended if you have time to prove your design and is optional
- 20 to 440 ton presses
- Tools registered, cataloged and stored on premises
- Tooling/presses/routing optimized for efficiency
- JIT service
- Short run stampings
- Simple parts and complex component parts
- Draws up to 3″ in depth
Get in touch with hardware mfg
1415 S. 18th
Saint Louis, MO 63104
Phone: (314) 436-0432
Fax: (314) 436-0481