5/16 Shank Economy Handles

Category: Handles

316 Stainless Steel Draw latches 4 hole bolt on springlatch with 3/4” pin

Description

		Padlocking Handle for Use with 6011 Locks (2) Locking handle may be used with the 6011 & 6013 Series locks. Heavy duty for use on truck bodies, farm cabs, electrical cabinets and storage cabinets. Note: Padlock not supplied. Handle: Cast Steel – Zinc plated & powder coated. Stainless – Polished Escutcheon: Steel – Zinc plated. Stainless – Polished Weight – 1 lb.




		Heavy Duty Non-Locking Lever Handle Heavy duty non-locking die-cast handle. Has 90º stops. This will allow either vertical or horizontal mounting. Holes – 1 1/2″ center to center in mounting plate. Shank – 5/16″ square x 4″ long. Finish – Chrome plated




		Rigid Type Heavy Duty Handle Rigid type heavy duty handle for truck and industrial use. Available keyed alike or keyed misc. Holes – 1-1/2″ center to center countersunk for no. 10 screws. Shank – 5/16″ x 4″ long. Finish – Chrome plated




		375 Locking Lever Handle Locking handle with 90º clockwise rotation. Available keyed alike or keyed misc. Holes – 1 3/4″ center to center, countersunk for no. 10 screws. Shank – 5/16″ x 4″ long. Finish – Chrome plated




		376 Non-Locking Lever Handle Non Locking handle with 90º clockwise rotation. Available keyed alike or keyed misc. Holes – 1 3/4″ center to center, countersunk for no. 10 screws. Shank – 5/16″ x 4″ long. Finish – Chrome plated.




		Rigid Type Heavy Duty Non-Locking Handle Rigid type heavy duty Non-Locking handle for truck and industrial use. Available keyed alike or keyed misc. Holes – 1-1/2″ center to center countersunk for no. 10 screws. Shank – 5/16″ x 4″ long. Finish – Chrome plated.




		Rigid Type Heavy Duty Handle Free Spinning When Locked Rigid type heavy duty handle Free spinning when locked for truck and industrial use. Available keyed alike or keyed misc. Holes – 1-1/2″ center to center countersunk for no. 10 screws. Shank – 5/16″ x 4″ long. Finish – Chrome plated




		Non-Locking L-Handle Non-locking L-handle with 360º rotation Holes – 1 1/2″ center to center, countersunk for no. 10 screws. Shank – 5/16″ x 4″ long. Finish – Chrome plated.




		Locking and Non-Locking Handles (2) Locking T-handle has 90º stops. Available keyed alike or keyed misc. Holes – 1 1/2″ center to center countersunk for no. 10 screws. Shank – 5/16″ square x 4″ long. Finish – Chrome plated




		Inside Handle Heavy duty non locking die-cast inside handle, complete with set screw. Fits on a 5/16″ square shaft. Finish – Chrome plated