(314) 436-0432

Standard Hinge Terminology

We’ve found that for large and small needs alike, it’s important to be equipped with an excellent understanding of the hinge terminology associated with industrial type hinges.

GAUGE
The thickness of a hinge leaf.
LEAF
The portion of a hinge extending laterally from the knuckle and which usually revolves around a pin.
LEAF WIDTH
The dimension from the center of the pin to the outer edge of the leaf.
HINGE WIDTH (same as open width)
The overall dimension of the leaves measured perpendicular to, or across, the pin.
PIN
Rod running the length of the hinge. The pin holds the leaves of the hinge together.
KNUCKLE
The hollow circular part at the joint of a hinge through which a pin is passed. The knuckle is often called a loop, joint, node or curl.
KNUCKLE LENGTH
The nominal or typical dimension of the knuckle measured parallel to the pin.
HINGE LENGTH
The length of the leaves measured parallel to the pin.
PITCH
The dimension from a point on the knuckle to the same point on an adjacent knuckle on the same leaf.
PAINT CLEARANCE
The minimum dimension between the outer face of the knuckle and the opposing edge of the cutout over the hinge’s entire range of pivotal movement.
END PLAY
The amount of axial movement between the leaves.
PLAIN OR STANDARD ASSEMBLY

Not sure what kind of hinge you need, or not familiar with the terminology? Call Marlboro Hinge to speak with a professional.This is a surface-type hinge. The leaves lie flat in the same plane when in the open position. Unless otherwise indicated, this type of  hinge will be furnished.

SWAGING
The forming of one or both leaves toward or beyond the center of the pin, swaging slightly increases leaf width. Contact a Marlboro Hinge engineer to discuss which hinge is right for your project.
BOTH LEAVES HALF-SWAGED
Both leaves are swaged approximately one-half the pin diameter with a minimum clearance between leaves when parallel. Turn to Marlboro Hinge for a wide array of standard hinges. Give us a call today.
ONE LEAF HALF-SWAGED
One leaf swaged one half the pin diameter. Find one leaf hald swaged hinges at Marlboro Hinge. Contact us today for a quote.
ONE LEAF FULL-SWAGED
One leaf swaged equal to the pin diameter and both leaves parallel when in a closed position. Standard Hinges - One Leaf Swaged
REVERSE SWAGED
One leaf swaged to simulate reverse assembly. Leaves will not close to a parallel position. Contact Marlboro Hinge for standard and custom reversed swaged hinge
OFFSET
Forming one or both leaves away from the center of the pin. Offsetting slightly decreases leaf width. Standard Hinges - Offset
STOP HINGE
A hinge manufactured to limit the travel of the leaves to a specified angle. Contact Marlboro Hinge for quality stop hinges today.
INSIDE STOP HINGE
Leaves will open from a closed position, leaves parallel to each other, to a stop angle as specified.

 

OUTSIDE STOP HINGE
Leaves move from an open or flat position and stop at a specified angle.  Marlboro Hinge offers a wide variety of standard stop arc hinges. Call us today.

 

Get in touch with hardware mfg 

 

Hardware MFG
1415 S. 18th
Saint Louis, MO 63104
HardwareMFG@aol.com
Phone: (314) 436-0432
Fax: (314) 436-0481

 

Copyright 2018 Hardware MFG. All rights reserved

Website Design by BPN-web-services