Steel Push Pull Fasteners with Clip

Steel Push Pull Fasteners with Clippush Pull w clip

  • A Stud suitable for use with any Oddie 600 Series Clip
  • Made from zinc plated steel
  • Alternative lengths available to special order
  • fastener w clip drawing
Material Zinc Plated Part Number
Steel Zinc Plated 410108
Steel Push Pull Fastenerssteel push pull fasteners
A range of case hardened zinc plated steel studs with rivet-on or clip-in spring steel clips in a phosphate finish. Dacromet finish can be supplied on the clips for applications requiring greater surface protection.

 

Clip in clips are front mounted into a round hole making them particularly suitable for blind hole fixing in square tubes.
Studsstudsstud drawing
Note: Type C to special order – please specify
Thread Type L G Part Number
4.2 self tapping 11.4 8 600079
M4 B 11.4 10 600080
M5 B 11.4 10 600081
M5 B 12.0 5 600082
M4 B 12.4 7 600083
M5 B 14.0 4 600084
M5 B 14.0 7 600085
M4 B 12.7 5 600086
M5 B 12.0 10 600087
M5 B 12.7 4 600088
M5 B 12.7 10 600089
M4
B
14.0
10
600090
M5
B
14.0
10
600091
M6
A
25.0
10
600092
  • General tolerance ± 0.3
  • Material: case hardened and zinc plated steel
  • Custom design available on request

Clip-in Clipsclip-on clipsclip on drawing

L Panel Thickness P A B D E F Part Number
11.4 0.5-1.0 13.4 6.0 17 0.4 10.5 600068
12.0 1.0-1.5 13.8 6.0 17 0.4 10.5 600069
12.7 1.5-2.0 14.2 6.0 17 0.4 10.5 600070
12.7 1.7-2.5 14.2 6.0 17 0.4 10.5 600071
14.0 2.5-3.2 15.8 6.0 17 0.4 10.5 600072
12.7 1.7-2.5 14.6 6.0 25 0.4 10.5 600073
  • General tolerance ± 0.3
  • Clips also fit into a 9 x 7mm rectangular hole
  • Material: spring steel – phosphate finish
  • Custom design available on request

 

 

rivet drawing

Panel Thickness P A B C D E h L Unlocking Force daN Part Number
1.5-5.0 50 17 37 8 0.6 16.5 25 8 600074
1.5-5.0 50 17 37 3.2 0.6 16.5 25 8 600096
3.5-5.0 26 11 19.5 8 0.6 7.5 14 9 600076
2.0-3.5 26 11 19.5 8 0.5 7.5 14 6 600077
1.0-2.0 26 11 19.5 8 0.3 7.5 14 3 600078
  • General tolerance ± 0.3
  • Panel Thickness P is the minimum and maximum frame thickness for a stud of length L shown on the stud table.
  • Material: spring steel – phosphate finish
  • Custom design available on request